Testimonials
Linn Products Testimonial
Click the link above to read about how MagLube’s process helped Linn Products Inc. reduce lubricant usage, increase tool life and improve their manufacturing process.
ATLANTA, GA
My name is Scott and I own a sign company in Atlanta, Georgia. I was introduced to MagLube about 2 years ago from friend who runs a machine shop. We were previously using a misting system that went through several gallons of cutting fluid per week. It was messy, and clouded up the shop with its over-spray. I was immediately impressed with the MagLube system during the first trial run, but didn’t realize the savings potential until a few weeks later. We now use 1 gallon of lubricant every 6 months, and my cost for replacement bits have decreased by over 50%. I also had a full-time employee whose entire job was to sand the burrs off the edges of aluminum lettering. With this system, the surface finishes are much better and that position is no longer necessary. The long-term savings with this product is tremendous!
DALLAS, TX
I run a steel service center in Dallas, Texas. We switched from flood coolant based cutting to micro-lubrication (MagLube) about 6 years ago. The immediate result was a clean shop, we no longer had to mop and clean the floors on a daily basis. The air no longer smelled of recycled flood coolant. This made the operators happy and gave them a safer environment in which to work. My blade life was extended by 30-40%, and my cutting fluid expense was cut dramatically. The cuts are straighter and clean, and productivity is better due to increased feed rates. I whole-heartedly endorse this product.
Liakos Industrial Sales – Distributor
In my 25 years of selling industrial equipment, I’ve never sold a product that is so revolutionary. MagLube literally changes, for the better, the way manufacturers do lubrication. I like the fact that the lubricants are environmentally friendly. My customers like the fact that the micro-lubrication systems are virtually maintenance free. They also like the fact that usage is cut back to a mere fraction of conventional lubricants, tool life is almost always close to doubling, and the mess associated with most other lubricants and lubrication methods is eliminated.